16
41.
Remove the preattached 90mm Pulley (not
shown) from the “U”-bracket (64).
Attach the end of the Leg Lever Cable (75) to the
“U”-bracket (64) with an M8 Washer (90) and an M8
Nylon Locknut (34).
Note: Do not completely
tighten the Locknut; it should be tightened so
that only two threads of the Cable show past
the Locknut, as shown in the inset drawing.
42.
Locate the Swivel Low Cable (72), which is the
only remaining cable that has an eyelet on one
end and a ball on the other end. Route the eyelet
end of the Cable through the cage on the Long
Base (101) and through the Swivel Upright (5), as
shown. Make sure the Cable is over the short bar
inside the cage.
Attach a 90mm Pulley (78) to the indicated bracket
on the Long Base (101) with an M10 x 45mm Bolt
(93) and an M10 Nylon Locknut (87).
Make sure
the Cable is in the groove of the Pulley.
43. Wrap the Swivel Low Cable (72) under a 90mm
Pulley (78). Attach the Pulley and a pair of Pulley
Covers (68) to the indicated bracket on the Long
Base (101) with an M10 x 50mm Bolt (100) and an
M10 Nylon Locknut (87).
Make sure the large tabs
on the Pulley Covers are oriented as indicated.
39
40
41
42
92
64
75
78
68
68
90
72
87
62
100
34
43
75
91
87
3
101
78
Cage
93
87
5
72
101
100
78
87
68
68
75
39. Route the Leg Lever Cable (75) under a 115mm
Pulley (119). Attach the Pulley and a pair of Large
Pulley Covers (113) to the indicated side of the
Butterfly Upright (3) with an M10 x 95mm Bolt (92),
an M10 Washer (91), and an M10 Nylon Locknut
(87).
Make sure the tabs on the Pulley Covers
are oriented as indicated.
40. Wrap the Leg Lever Cable (75) over a 90mm Pulley
(78). Attach the Pulley and a pair of Pulley Covers
(68) to the Double “U”-bracket (62) with an M10 x
50mm Bolt (100) and an M10 Nylon Locknut (87).
Make sure the small tabs on the Pulley Covers
are on the bottom.
75
34
Tab
Large
Tab
Small
Tab
113
119
