13
24.
Remove the preattached 90mm Pulleys (78)
from the Offset Double “U”-bracket (61).
Wrap the Swivel Cable (17) around a 90mm Pulley
(78). Attach the Pulley to the Offset Double “U”-
bracket (61) with an M10 x 50mm Bolt (100) and an
M10 Nylon Locknut (87).
Make sure the small
tabs on the Pulley Covers are on the top.
25. Wrap the Swivel Cable (17) around a 90mm Pulley
(78). Attach the Pulley and a Pulley Cover (68) to
the next to bottom hole in the Small Pulley Plates
(31) with an M10 x 50mm Bolt (100) and an M10
Nylon Locknut (87).
Make sure the small tabs on
the Pulley Covers are on the bottom.
26. Wrap the Swivel Cable (17) around a 90mm Pulley
(78). Attach the Pulley and a pair of Pulley Covers
(68) to the bracket on the Swivel Upright (5) with an
M10 x 50mm Bolt (100) and an M10 Nylon Locknut
(87).
Make sure the small tabs on the Pulley
Covers are on the top.
27. Attach the end of the Swivel Cable (17) to the
bracket on the Swivel Carriage (46) with an M10 x
20mm Bolt (86) and an M10 Nylon Locknut (87).
28.
Locate the Lat Cable (88), which is 2263mm long
and has a ball on one end and an eyelet on the
other. Route the eyelet end of the Cable up through
the Butterfly Top Frame (7) and around a 90mm
Pulley (78). Attach the Pulley inside of the Butterfly
Top Frame with an M10 x 65mm Bolt (18), two M10
Washers (91), two 12mm Spacers (89), and an M10
Nylon Locknut (87).
28
25
26
27
100
78
68
68
78
68
68
46
87
17
86
17
87
18
87
88
91
91
89
89
7
78
31
87
100
5
24
78
87
100
17
61
Small
Tab
Small
Tab
Small
Tab
17
