Software Control Panel
Sample rate settings
Select your desired sampling rate from
44.1KHz to 192KHz on the pull down
window shown on Diagram 1. Click
"Apply" after the selection has been
made to set the value.
Diagram 1
Buffer Size settings
You may select the buffer size for
"Streaming" and "ASIO". Click "Apply"
after you have made the selections.
(Note: If a clicking sound occurs, you
should change to a larger buffer size for the
settings. If the largest buffer size has been
selected and there is still a clicking sound. It
means your computer performance is not
able to handle the task. (It is not caused by
the Umix 1008 Satellite digital audio interface)
Diagram 3
Device settings
Shows the serial number & product ID of
your Umix 1008 Satellite device. If it
doesn't show, it means your device is not
properly installed. Please go through the
“Driver Installation” process again
(Page 8).
Monitor Mixer
Click this button to launch the "Monitor
Mixer" (Page 12)
Playback Mixer
Click this button to launch the "Playback
Mixer" (Page 13)
S/PDIF Status and Pass Through
Showing the S/PDIF device signal status.
S/PDIF Pass Through
"Tick" the box if you want S/PDIF signal
pass through
11
Diagram 2
Diagram 4
