6
STEP 1
Attach front stabilizer (2) and rear stabilizer (4) to
main frame (1) by fixing Carriage bolt(6), Arc wash-
ers(8) and cap nut (9)
STEP 2
Thread the right pedal (11R)which marked “R” onto
the right side of the crank(10) , then circumvolved
easilly and tighten; Do the same way to thread the
left pedal (11L) which marked “L” onto the left side of
the crank (10), then circumvolve anticlockwise and
tighten
STEP 3
While another person holds the Upright (17) near the
Frame (1), connect the Extension Wire (15) to the
sensor Wire (13). Next, connect the Resistance Ca-
ble (14) to the Lower Cable (12) in the following way:
• See drawing A. Pull upward on the metal bracket
on the Lower Cable (12), and insert the tip of the Re-
sistance Cable (14) into the wire clip inside the metal
bracket as shown.
• See drawing B. Firmly pull the Resistance Cable
(14) upward and slide it into the top of the metal
bracket as shown.
• See drawing C. Using pliers, squeeze the prongs
on the upper end of the metal bracket together.
Push the Wires (13,15) and the Cables (12,14)
downward into the Frame (1).
Tip: Do not pinch the wires and cables. Insert the
Upright (17) into the Frame (1). Attach the Upright
with four Screws (16) and four Curved washer (8).
A
B
C
9
6
6
9
12
12
14
Metallic
support
Metallic
support
14