Glob settings
Glob Chan –
Setting the Glob channel from 1 to 16 for your InSpire-air controller
Velocity Curve –
Select your desired velocity curve from Curve 1-8 and F1-F3 in
the pull-down menu for your keyswitch velocity curve.
Pad Curve –
Select your desired velocity curve from Curve 1-4 and F1-F3 in the
pull-down menu for your pads velocity curve.
Control Mode –
Select “Mackie” control if you would like to use makie control
protocol otherwise select “User define” if you would like to set up your own
MIDI mapping for your Inspire-air controller.
Memory –
There are 20 non-volatile memory locations for you to store the
settings. Select the memory location from F1 to F20 to recall or make
modification for the settings.
Zone settings
Zone 1
~
Zone 4 –
Select the correspondence zone for settings by check mark
the circle.
Status –
Enable or disable the correspondence zone in the pull-down menu
Start / End –
Setting the zone range between the starting key and ending key.
Simply press the keyswitch above to set the start and end key values.
Chan -
Select your desired MIDI channel in the pull-down menu for the
correspondence zone.
Octave –
Setting the octave value from -2 to +5 in the pull-down menu for the
correspondence zone.
Transpose –
Setting the transpose value from -12 to +12 in the pull-down menu
for the correspondence zone.
Assign the MIDI channels, CC number and Min/Max range values to the fader
Select your desired MIDI channel, CC number and Min/Max range values in the
pull-down menu for the fader.
(Note: There are 3-layers of fader, 27 faders in total that you could assign)
Assign the MIDI channels, CC number and Min/Max range values to the knob
Select your desired MIDI channel, CC number and Min/Max range values in the
pull-down menu for the knob.
(Note: There are 3-layers of knobs, 24 knobs in total that you could assign)
Assign the MIDI channels, CC number and Min/Max range values to the pad
Select your desired MIDI channel, CC number and Min/Max range values in the
pull-down menu for the Pad.
(Note: There are 3-layers of pads, 24 pads in total that you could assign)
Assign the MIDI channels, CC number and Min/Max range values to the MMC buttons
Select your desired MIDI channel, CC number and Min/Max range values in the
pull-down menu for the MMC buttons.
TM
iMap InSpire-air series controller software panel
1
2
3
4
5
6
23
