2
5.
Install optional shock boot securing the top of the boot with the supplied zip-tie.
6.
Install the new Icon stem bushings onto the Icon shock. Place the washer with the bigger hole on, then a bushing. Place the stem
into the upper shock mount, then another bushing and the washer, thread on one of the supplied nuts, tighten it down until the
second nut can on and 3-4 thread show with both nuts installed.
[FIGURE 3]
7.
Install the lower eyelet of the Icon shock onto the axle stud. Use the supplied sleeves to position the eyelet correctly. Sleeve,
shock eyelet, sleeve. Use the factory bolt and torque to factory specs.
[FIGURE 4 & 5]
8.
For reservoir mounting, use the supplied reservoir bracket and hold the reservoir and bracket up to the frame as shown, and mark
the hole to drill it to 11/32” (SHOCK APPEARANCE MAY CHANGE DUE TO ONGOING DEVELOPMENT).
[FIGURE 6, 7, 8]
FIG.5
FIG.4
FIG.3
FIG.7
FIG.6
FIG.8
