31
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the
reed switch,
first unplug the
power adapter.
Using a standard
screwdriver,
carefully pry the
Shield Cover
(26) off the
Left and Right
Shields (37, 58).
Next, locate the Reed Switch (23). Slightly loosen the
M4 x 19mm Screw (50).
Next, rotate the Left Crank Arm (35) until a Magnet (54)
is aligned with the Reed Switch (23). Slide the Reed
Switch slightly toward or away from the Magnet. Then,
retighten the M4 x 19mm Screw (50).
Plug in the power adapter and rotate the Left Crank
Arm (35) for a moment. Repeat these actions until the
console displays correct feedback.
When the reed switch is correctly adjusted, reattach
the shield cover.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted.
To adjust the drive belt,
first unplug the power
adapter.
Next, carefully tip the exercise bike onto its
left side as shown.
Using an M10 socket wrench with an extension (not
included), reach into the opening in the bottom of the
Right Shield (58) and tighten the M10 x 50mm Screw
(49) a few turns until the Drive Belt (not shown) is tight;
do not overtighten the Drive Belt.
Then, tip the exercise bike upright, plug in the power
adapter, and pedal the exercise bike to test the drive
belt. Repeat this process, if necessary, until the pedals
no longer slip.
26
37, 58
50
35
23
54
58
49
Summary of Contents for Pro-Form Pro C10U
Page 4: ...4...
