18
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the rower is used. Replace
any worn parts immediately.
To clean the rower, use a damp cloth and a small
amount of mild detergent. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
For best results, clean the rail, the seat carriage, and
the carriage rollers daily.
CONSOLE TROUBLESHOOTING
Most console problems are the result of low batteries;
for replacement instructions, see assembly step 8 on
page 9.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, you must remove the
resistance handle and the right and left shields as
described below.
First, remove
the six M4 x
10mm Screws
(70) and then
gently remove
the Resistance
Handle (9).
See the EXPLODED DRAWING on page 23.
Locate the Right and Left Shields (7, 8). Remove the
four M4 x 19mm Screws (69) and the ten M4 x 16mm
Screws (68) from the Right and Left Shields. Then,
gently remove the Right and Left Shields.
Next, locate the Reed Switch (47). Turn the Left Fan
(4) until a Magnet (85) is aligned with the Reed Switch.
Slightly loosen the two indicated M4 x 19mm Screws
(69), slide the Reed Switch slightly closer to or away
from the Magnet, and then retighten the Screws.
Turn the Left Fan (4) so that the Magnet (85) passes
the Reed Switch (47) repeatedly. Repeat these actions
until the console displays correct feedback.
When the reed switch is correctly adjusted, reattach
the parts that you removed.
70
70
9
4
69
85
47
MAINTENANCE AND TROUBLESHOOTING
Summary of Contents for NTRW59146.0
Page 4: ...UTS 4 all STANDARD SERVICE PLANS...
Page 21: ...21 NOTES...
