12
14. Attach the Right Handrail (5) to the Frame (1)
with three M10 x 19mm Patch Screws (61) and
three M10 Split Washers (79).
Press the posts on the Right Rail Cover (7) into
the indicated holes in the Frame (1).
Attach the Left Handrail (4) and the Left Rail
Cover (6) in the same way.
14
5
61
61
79
79
4
1
7
6
15. Identify the Right Handlebar (11), which is
marked with an “R” sticker. Orient the Right
Handlebar as shown.
Attach the Right Handlebar (11) to the Upright
(2) with three M8 x 25mm Flat Patch Screws
(68). Then, slide a Handlebar Cover (31) onto
the Right Handlebar and attach it with three M4
x 16mm Screws (67).
Attach the Left Handlebar (not shown) in the
same way.
See step 2.
Tighten the M10 x 19mm Patch
Screws (61).
See step 13.
Tighten the M8 x 13mm Patch
Screws (62).
11
68
68
67
31
15
2
16. Plug the power adapter into the jack on the frame of the elliptical exerciser (see HOW TO PLUG IN THE
POWER SUPPLY on page 13).
IMPORTANT: If the elliptical exerciser has been exposed to cold tem-
peratures, allow it to warm to room temperature before plugging in the power cord. If you do not do
this, the console displays or other electronic components may become damaged.
Make sure that all parts are properly tightened before you use the elliptical exerciser.
Note: After
assembly is completed, some extra parts may be left over. Place a mat beneath the elliptical exerciser to
protect the floor.
Holes
Summary of Contents for NordicTrack A.C.T
Page 23: ...23 NOTES...
