30
3
1. It is the responsibility of the owner to ensure
that all users of this treadmill are adequately
informed of all warnings and precautions.
2. Use the treadmill only as described in this
manual.
3. Place the treadmill on a level surface, with at
least 2,5 m (8 ft.) of clearance behind it and
0.5 m (2 ft.) on each side. Do not place the
treadmill on a surface that blocks any air
openings. To protect the floor or carpet from
damage, place a mat under the treadmill.
4. Keep the treadmill indoors, away from mois-
ture and dust. Do not put the treadmill in a
garage or covered patio, or near water.
5. Do not operate the treadmill where aerosol
products are used or where oxygen is being
administered.
6. Keep children under the age of 12 and pets
away from the treadmill at all times.
7. The treadmill should not be used by persons
weighing more than 115 kg (250 lbs.).
8. Never allow more than one person on the
treadmill at a time.
9. Wear appropriate exercise clothes when
using the treadmill. Do not wear loose clothes
that could become caught in the treadmill.
Athletic support clothes are recommended for
both men and women. Always wear athletic
shoes. Never use the treadmill with bare feet,
wearing only stockings, or in sandals.
10. When connecting the power cord (see page 9),
plug the power cord into an earthed circuit. No
other appliance should be on the same circuit.
When replacing the fuse, an ASTA approved
BS1362 type should be fitted to the fuse car-
rier. A 13 amp fuse should be used.
11. If an extension cord is needed, use only a 3-
conductor, 1 mm
2
(14-gauge) cord that is no
longer than 1.5 m (5 ft.).
12. Keep the power cord and the surge suppres-
sor away from heated surfaces.
13. Never move the walking belt whilst the power
is turned off. Do not operate the treadmill if
the power cord or plug is damaged, or if the
treadmill is not working properly. (See
BEFORE YOU BEGIN on page 5 if the tread-
mill is not working properly.)
14. Never start the treadmill whilst you are stand-
ing on the walking belt. Always hold the
handrails whilst using the treadmill.
15. The treadmill is capable of high speeds.
Adjust the speed in small increments to avoid
sudden jumps in speed.
16. Using hand weights and not holding the
handrails may compromise your ability to
maintain your balance. Hand weights should
be used only by experienced users.
17. The pulse sensors are not medical devices.
Various factors, including the user's move-
ment, may affect the accuracy of heart rate
readings. The pulse sensors are intended only
as exercise aids in determining heart rate
trends in general.
18. Never leave the treadmill unattended whilst it
is running. Always remove the key, unplug
the power cord, and move the on/off switch to
the off position when the treadmill is not in
use. (See the drawing on page 5 for the loca-
tion of the on/off switch.)
19. Do not change the incline of the treadmill by
placing objects under the treadmill.
20. Do not attempt to raise, lower, or move the
treadmill until it is properly assembled. (See
ASSEMBLY on page 6, and HOW TO FOLD
AND MOVE THE TREADMILL on page 23.) You
must be able to safely lift 20 kg (45 lbs.) in
order to raise, lower, or move the treadmill.
21. When folding or moving the treadmill, make
sure that the storage latch is fully closed.
WARNING:
To reduce the risk of burns, fire, electric shock, or injury to persons, read the
following important precautions and information before operating the treadmill.
IMPORTANT PRECAUTIONS
PART LIST—Model No. NETL11520
R0602A
To locate the parts listed below, see the EXPLODED DRAWING attached in the centre of this manual.
Key No. Qty.
Description
Key No. Qty.
Description
1
1
Allen Wrench
2
2
Wheel Bolt
3
1
Left Rear Endcap
4
2
Roller Adj. Lock Washer
5
2
Rear Roller Adj. Bolt
6
2
Rear Wheel
7
8
Front Wheel Nut/Frame Pivot Nut
8
8
Endcap Screw
9
1
Roller Guard (Left)
10
1
Right Roller Guard
11
1
Right Rear Endcap
12
1
Roller Ground Wire
13
1
Filter Wire
14
1
Rear Roller
15
1
Warning Decal
16
1
Latch Plate
17
2
Latch Plate Screw
18
2
Frame Pivot Bolt
19
1
Left Front Endcap
20
2
Belt Guide
21
1
Foot Grip (Left)
22
1
Walking Belt
23
1
Walking Deck
24
1
Foot Grip (Right)
25
1
Power Board
26
1
Right Front Endcap
27
2
Support Bracket Screw
28
1
Support Bracket
29
1
Front Roller/Pulley
30
1
Magnet
31
6
Console Screw (Long)
32
2
Thrust Washer
33
2
Frame Pivot Bushing
34
2
Frame Pivot Spacer
35
1
Reed Switch
36
1
Reed Switch Clip
37
1
iFIT.com Wire
38*
1
Motor Assembly
39
1
Flywheel/Pulley
40
1
Motor Belt
41
1
Motor Pivot Nut
42
4
Motor Tension Nut/Lift Frame Nut
43
1
Motor Tension Washer
44
2
Hand Weights
45
1
Motor Pivot Bolt
46
1
Motor
47
1
Lift Frame
48
1
Motor Star Washer
49
10
Screw
50
1
Jack
51
1
Key/Clip
52
1
Incline Motor Bolt (Top)
53
8
Endcap Washer
54
1
Incline Motor Stop
55
8
Endcap Nut
56
2
Motor Tension Bolt/
Incline Motor Bolt, Lower
57
1
Incline Motor
58
1
Front Roller Bolt
59
4
Plastic Stand-off
60
1
Electronic Plate
61
1
Controller
62
1
Motor Controller Wire
63
1
Power Cord Set
64
1
Receptical
65
1
On/Off Switch
66
2
Long Belly Pan Screw
67
1
Audio Wire Nut
68
1
Circuit Breaker
69
2
Static Decal
70
1
12” Audio Wire
71
1
Belly Pan
72
4
3/4” Screw
73
1
Filter
74
1
Choke
75
3
Base Pad
76
1
Console Base
77
1
Book Holder
78
1
Console
79
2
Handrail Endcap
80
2
Pulse Grip
81
4
Pulse Grip Screw
82
10
Short Console Screw
83
1
Console Back
84*
2
Extension Leg Assy.
85
2
Extension Leg Endcap
86
8
Base Screw
87
2
Incline Motor Spacer
88
2
Extension Leg
89
1
Handrail
90
4
Thick Base Pad
91
1
Motor Hood
92
1
8” Wire Tie
93
2
Cable Tie Clamp
94
2
Clamp Screw
95
1
Releasable Tie
96
2
Lift Pivot Bolt
97
2
Front Wheel Bolt
98
2
Front Wheel
99
1
Incline Motor Guard
100
1
Upright Grommet
101
1
Upright Wire
102
1
Lock Pin
103
1
Pin Clip
