26
SYMPTOM: The console does not display speed
and distance correctly
a.
Remove the key from the console and
UNPLUG
THE POWER CORD.
Next, remove the indicated
#8 x 3/4" Screw (5), and lift off the Left Foot Rail
Cover (44).
Next, locate
the Reed
Switch (98)
and the
Magnet (104)
on the left side
of the Pulley
(42). Turn the
Pulley until
the Magnet
is aligned
with the Reed
Switch.
The
gap between the Magnet and the Reed Switch
must be about 1/8 in. (3 mm).
If necessary,
loosen the #8 x 3/4" Clip Screw (97), move the
Reed Switch slightly, and then retighten the Clip
Screw. Then, see the larger drawing above and
reattach the Left Foot Rail Cover (44) with the
#8 x 3/4" Screw (5), and run the incline trainer for a
few minutes to check for a correct speed reading.
SYMPTOM: The walking belt slows when walked on
a.
If an extension cord is needed, use only a 3-conduc-
tor, 14-gauge (2 mm
2
) cord that is no longer than
5 ft. (1.5 m).
b.
If the walking belt is overtightened, incline trainer
performance may decrease and the walking belt
may become damaged. First, adjust the incline to
40 percent. Then, remove the key and
UNPLUG
THE POWER CORD.
Using the hex key, turn both
idler roller screws counterclockwise, 1/4 of a turn.
When the walking belt is properly tightened, you
should be able to lift each edge of the walking belt
3 to 4 in. (8 to 10 cm) off the walking platform. Be
careful to keep the walking belt centered. Then,
plug in the power cord, insert the key, and walk on
the incline trainer for a few minutes. Repeat until
the walking belt is properly tightened.
c.
Your incline trainer features a walking belt coated
with high-performance lubricant.
IMPORTANT:
Never apply silicone spray or other substances
to the walking belt or the walking platform
unless instructed to do so by an authorized
service representative. Such substances may
deteriorate the walking belt and cause exces-
sive wear.
If you suspect that the walking belt
needs more lubricant, see the front cover of this
manual.
d.
If the walking belt still slows when walked on, see
the front cover of this manual.
44
a
5
3–4 in.
b
Idler Roller Screws
104
42
97
98
1/8 in.
Top View
