INSTRUCTIONS
SEPARATION KIT
RMK-3
Thank you for purchasing the
RMK-3
SEPARATION KIT
.
The RMK-3 allows you to install the mobile trans-
ceiver front panel separately from the main body for
added installation convenience and operation. Use
either the optional OPC-607, OPC-608 or OPC-609
SEPARATION CABLE
with the RMK-3.
• In this instruction, the illustration is described using the IC-
F5060 series transceiver.
■
Separation
The optional OPC-607
(3 m; 9.84 ft)
, OPC-608
(8 m; 26.3 ft)
or
OPC-609*
(1.9 m; 6.3 ft)
SEPARATION CABLE
is required for in-
stalling the transceiver front panel and main body separately.
*For Europe version, only the OPC-609 is available.
q
Turn the transceiver’s power OFF, then disconnect the DC
power cable.
w
Unscrew the 4 bottom screws, then remove the bottom
cover from the transceiver in the direction of the arrow.
e
Remove the front panel from the main body using a stan-
dard screw driver as shown below.
r
Disconnect the flat cable from the front panel.
t
Unscrew the 4 rear plate screws, then remove the rear
plates from both the front panel and main body attach-
ments.
☞
Continue to the back page.
Rear plate
*This illustration
shows the descrip-
tion for the front
panel attachment.
Unscrew the cir-
cuit board screw.
Front panel
Flat cable
Main body
Front panel
Flat cable
Main body
Front panel
Standard
screw driver
q
w
e
Bottom cover
CAUTION!
To avoid damage to the transceiver, turn the
power OFF before separating the front panel from the
main body.
■
Supplied accessories
Main body attachment
Front panel attachment
Flat cable
Mounting bracket
Flat washers
(M5)
Spring washers
(M5)
Mounting screws
(M5
×
12)
Self-tapping screws
(M5
×
16)
Bracket screws
Nuts (M5)
Icom, Icom Inc. and the
logo are registered trademarks of Icom Incor-
porated (Japan) in the United States, the United Kingdom, Germany, France,
Spain, Russia and/or other countries.
