4-1
SECTION 4 OPTIONAL CABLE INSTALLATION
║
CAUTION!
Optional cable must be installed at only the authorized Icom service centers.
║ The performance capability of the transceiver cannot be guaranteed if the user installs a cable themselves, or has it done at
║ a non-authorised dealer/service center.
NOTE:
Be sure to keep the equipment in a secure place to avoid inadvertent use by unauthorized persons.
■
INSTALLING THE OPC-2407
1. Turn OFF the transceiver and disconnect the DC power cable.
2. Eliminate all static electricity from your body before touching the unit.
3. Remove the top cover following the DISASSEMBLY INSTRUCTIONS in SECTION 3.
4. Remove the bushing plate, and then the bushing rubber from the chassis.
5. Remove the O-RING from the bushing rubber.
Bushing plate
Bushing rubber
Chassis
O-RING
6. Attach the O-RING to the bushing of the OPC-2407.
NOTE:
If the O-RING is damaged, replace it to a new one to maintain the dustproof/waterproof performance.
OPC-2407
Bushing
Insert all the way
O-RING
7. Insert the OPC-2407 from the rear of the chassis.
8. Attach the bushing to the chassis, paying attention to the direction of the convex part of the bushing.
If the direction of the convex part of the bushing is reversed, the dustproof/waterproof performance cannot be maintained.
9. Attach the bushing plate to fix the cable.
10. Attach the connector of OPC 2407 to J502 on the MAIN-A UNIT.
Chassis
J502
J502
OPC-2407
MAIN-A UNIT
Convex part
Bushing
Bushing
Bushing plate
