3
ADVANCED OPERATION
3-13
Emergency Call function
D
Lone Worker function
NOTE:
The Lone Worker may not properly work, depending on the surrounding environment such as the battery
capacity, the signal strength, or the access point or network status. Icom is not responsible for the destruction or
damage caused by using the Lone Worker function�
The transceiver may enter the Emergency mode through the following functions, depending on the Controller
setting�
When no operation occurs for the ON Timer preset
time, the transceiver enters the Emergency mode.
L
If you push any key before the Reminder Timer preset
time expires, the Emergency mode is canceled.
Lone Worker with Stationary
The transceiver enters the Emergency mode when:
• No operation occurs for the ON Timer preset time�
AND
• The transceiver is detected as stationary (no
motion) for the ON Timer preset time�
L
If you push any key, or move the transceiver before the
Reminder Timer preset time expires, the Emergency
mode is canceled�
Operation
Time
Enters the
Emergency mode�
Sends an
Emergency call�
[PTT]
[PTT]
[PTT]
No operation
is detected�
ON Timer
Reminder Timer
Emergency Timer
[KEY]
If any key is pushed
during Reminder Timer,
the Emergency mode is
canceled�
Acceleration
Time
Enters the
Emergency mode�
Sends an
Emergency call�
Stationary
Sensitivity
ON Timer
Reminder Timer
Emergency Timer
Operation
[KEY]
[PTT]
If any key is pushed
during the Reminder
Timer, the Emergency
mode is canceled�
No operation
is detected�
No motion is
detected�
If moved during the Reminder
Timer, the Emergency mode is
canceled�