1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan
A-7125W-1EX-
q
Printed in Japan
© 2014
–2017 Icom Inc.
INITIALIZING IP1000C
ABOUT THE FIRMWARE UPDATE FUNCTION
When [MSG] lights green
Disconnect all cables from the IP1000C, and then con-
nect the AC adapter.
• Verify that the [PWR] indicator lights green.
Push in and hold [INIT] with a pin on the rear panel until
all indicators on the front panel light orange, and then
release.
•
When the initialization has been completed, [PWR]
lights green.
This function lights the [MSG] LED green to indicate that an
IP1000C update is available.
• To use the Firmware Update function, an internet connection,
DNS and default gateway settings are necessary.
See the IP1000C instruction manual for the setting details, or
contact your Icom dealer or distributor for advice.
NOTE:
•
NEVER turn OFF the power until the update has complet-
ed. Otherwise, the IP1000C firmware may be damaged.
• The firmware update cannot be performed during a conver-
sation using the IP1000C.
* Indications other than [PWR] and [MSG] may differ, depending on
the network environment (Except for when all LEDs light.)
:Black out
<Status>
[LED indication]
[Operation]
:Light
:Blink
Turn ON the power
Use
a pin
AC
adapter
後面部
Rear
panel
[
INIT
]
Push in and hold
Release
Lights
(Green)
Blinks
(Orange)
Lights
(Orange)
Blinks
（
Orange/Green
）
Blinks
（
Green
）
All LEDs light
（
Orange
）
Lights
(Green)
Use a pin
Push in
and hold
Front
panel
Release
:Black out
<Status>
[LED indication*]
[Operation]
:Light
:Blink
After the rebooting,
[PWR] lights green.
Lights
(Green)
Blinks
(Green)
All LEDs light (Orange)
1
2
If you cannot access to the IP1000C setting screen, you can initialize (reset) the IP1000C by pushing [INIT] on the rear panel.
• This initializing resets all settings to the factory defaults.
• See the IP1000C instruction manual for initializing from the setting screen.
When [MSG] lights green, a firmware update is available. Follow
the procedures below to download and install the new firmware.
Push in and hold [UPDATE] with a pin on the front panel until
[MSG] blinks, and then release.
• The IP1000C automatically starts the download and updates
the firmware, and then reboots.
All stated specifications and design are subject to change without notice or obligation.
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the
United Kingdom, Germany, France, Spain, Russia, Australia, New Zealand, and/or other countries.
All other products or brands are registered trademarks or trademarks of their respective holders.
ABOUT THE AUTOMATIC FIRMWARE UPDATE FOR THE IP100H
The IP100H has a function that checks for a firmware update while booting. If available, the IP100H automatically updates and
then reboots when the update has completed.
• The firmware may be updated and the IP100H reboots right after turning ON the power.
• This “
Automatic Firmware Update at Power ON” function can be set in Transceiver Settings > Transceiver Settings > Maintenance of
the IP1000C setting screen.
