Icom iF610, Instruction Manual

Page: 13 / 36

8
2
OPERATION
D D
Making a Status Call
A status message may be sent to the despatcher or a remote
station having an individual code. (No status message can be
sent to any station using a group code.)
•Sending a status message to a station having an individual
code.
q
Display an individual code by pushing [ ]/[ ].
w
Push the Status Up [ ∫ ]/Down [ √ ] to enter the status code
select mode.
➥
Select the desired message from a total of 32 different
status messages having code No. 0 through 31.
➥
Status code 0 means “Call Back Request” -- Please call
back, and status code 31 “Previous Request Cancel” --
Cancels the call. These status codes are commonly
used by all systems.
e
Push [PTT], the status message will be sent to the station
having the selected individual code.
r
When the status message has been successfully sent out,
‘OK’ appears on the display.
D D
Sending a status message to the Despatcher
q
Enter the Despatcher mode by pushing the [Despatcher].
w
Push [Despatcher] again. Now you are ready to select a
status code.
➥
If the direct call to the despatcher is selected, you can-
not use status code select condition.
e
Push [ ∫ ]/[ √ ] to select the desired status message.
➥
Select the desired message from a total of 32 different
status messages having code No. 0 through 31.
➥
Status code 0 means “Call Back Request” -- Please call
back, and status code 31 “Previous Request Cancel” --
Cancels the call. These status codes are commonly
used by all systems.
r
Push [PTT] to send the status message to the despatcher.
t
When the status message has been successfully sent out,
‘OK’ appears on the display.
PERSONAL 1
STATUS 01
DESPATCHER
STATUS 01
IC-F610_F620_MPT_1.qxd 05.8.22 6:07 PM Page 8 (1,1)