6-3
■
ABOUT THE ADJUSTMENT SOFTWARE (ID-RP3 ADJ)
1
File
The File menu contains sub-menus that you use to open,
and save data file, and to exit the software.
Open... (Ctrl+O)
Click to open a data file (.icf).
• The Adjustment data is not written to the repeater at opening a file.
Save (Ctrl+S)
Click to save the settings to a data file (.icf).
• You need to load the data to save from the repeater.
Save As...
Click to save the current settings with a different file name, or
in a different location.
If the same file name exists in the selected folder, a warning
message appears. Click <OK> if you want to overwrite it,
otherwise change the file name or location and then save it.
• You need to load the data to save from the repeater.
Recent File
Click to show up to the last four files that you accessed.
Select a file for simple reloading.
Exit (Alt+F4)
Click to close the software.
2
View
The View menu contains sub-menu that you use to change
the font size and to hide or display the toolbar.
Font Size
Click to select the font size of the contents list screen.
Toolbar
Click to hide or display the toolbar.
The toolbar has 3 function icons, Open, Save, and load the
adjustment data.
3
COM Port
Setting
Opens the “COM Port Setting” window.
Select the number of the COM port that the repeater is
connected to.
You may also search the COM port number that the ID-
RP2010V is connected to, by clicking <Search> on the “COM
Port Setting” window.
• The “ID-RP3 Search” window appears.
4
Adjustment
Read <- Repeater
Loads the adjustment value from the repeater.
NOTE:
Check the following if an error message appears.
• The correct port number is set in the [COM Port] menu.
• The repeater and PC are correctly connected together with
the programming cable.
• The repeater is turned ON.
5
Tool
All Reset
Performs the Repeater All Reset.
All Reset returns all repeater settings to their default value.
• [TX] and [RX] blink until the repeater setting data is newly programmed.
NOTE:
It is recommended that you save the programming data of
the repeater with the programming software before adjusting.
6
Help
About ID-RP3 ADJ
Click to open the information window which displays the
revision number of the software.
Click <OK> to close the window.
(This window is an example.)
Toolbar
Clcik to open the Adjustment screen
(Refer to page 6-5)
Clcik to open the Test screen
(Refer to page 6-4)
1
2
3
4
5
6
