![background image](http://html1.mh-extra.com/html/icom/ic-v3mr/ic-v3mr_instruction-manual_2038132005.webp)
iv
INTRODUCTION
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
CAUTION:
Changes or modifications to this
transceiver, not expressly approved by Icom Inc.,
could void your authority to operate this transceiver
under FCC regulations.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the condition that this device
does not cause harmful interference.
•
DO NOT
operate or adjust all controls,
adjustments, and switches without resulting in a
violation of the FCC rules.
•
DO NOT
replace any transmitter components
such as crystal, semiconductor, and so on. It could
result in a violation of the FCC rules.
Adjustment of this radio should be performed by or
under the immediate supervision and responsibility
of Icom Inc. or:
• A person certified as technically qualified to
perform transmitter maintenance and repair duties
in the private land mobile services.
• Services by an organization or committee
representative of the private land mobile services
user.
• Since FCC Part 95.2725 requires monitoring the
channel before transmit, Lock-out (Busy lockout)
must be enabled if Moni (Monitor) button was
disabled.
FCC INFORMATION