Icom IC-M411, Instruction Manual

Page: 17 / 64

11
4
SCAN OPERATION
New2001
4
n
Setting TAG channels
For more effcent scannng, add the desred channels as
TAG channels or clear the TAG for unwanted channels.
Channels that are not tagged wll be skpped durng scan-
nng. TAG channels can be assgned to each channel group
(INT, USA, ATIS or DSC) ndependently.
q
Push both [ Y ] and [ Z ] to select the desred channel
group, f desred.
w
Select the desred channel to be set as a TAG channel.
e
Push and hold [SCAN•TAG] for 1 sec. to set the dsplayed
channel as a TAG channel.
• “ ” appears n the dsplay.
r
To cancel the TAG channel settng, repeat step
e
.
• “ ” dsappears.
✓
Clearing (or setting) all tagged channels
Whle pushng [HI/LO] on the mcrophone, push and hold
[SCAN•TAG] for 3 sec. (untl a long beep changes to 2 short
beeps) to clear all TAG channels n the channel group.
• Repeat above procedure to set all TAG channels.
n
Starting a scan
Set scan type (Prorty or Normal scan) and scan resume
tmer n advance, usng Set mode. (p. 40)
q
Push both [ Y ] and [ Z ] to select the desred channel
group, f desred.
w
Set TAG channels as descrbed at left.
e
Make sure the squelch s closed to start a scan.
r
Push [SCAN•TAG] to start Prorty or Normal scan.
• “SCAN” blnks at the channel comment ndcator durng scan-
nng. (Durng Prorty scan, “16” appears besde the blnkng
“SCAN” ndcaton.)
• A beep tone sounds and “16” blnks at the channel comment n-
dcator when a sgnal s receved on Channel 16 durng Prorty
scan.
• When a sgnal s detected, scan pauses untl the sgnal dsap-
pears or resumes after pausng 5 sec. accordng to Set mode
settng. (Channel 16 s stll montored durng Prorty scan.)
• Push [ Y ] or [ Z ] to check the scannng TAG channels, to
change the scannng drecton or resume the scan manually.
t
To stop the scan, repeat step
r
.
[Example]
: Starting a Normal scan.
Push
Scan starts.
When a signal is
received.
Blinks Blinks
Appears