9
4
CONNECTIONS AND MAINTENANCE
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Microphone installation
■
The HM-195 should be connected to the transceiver using
the supplied OPC-1540 connection cable. The cable is used
to operate from a longer distance. The cable connector can
also be installed as a built-in plug on a cabinet or wall.
To operate from even longer distances, the optional 6 meter
long OPC-1541 extension cable can be used between the
transceiver and the OPC-1540. Up to two OPC-1541 can be
added.
Installation
D
Insert the OPC-1540 cable connector into the command
q
microphone jack, and tighten the nut.
To use the cable connector as a wall socket, install it as
w
described to the right.
Using the mounting base as a template, carefully mark the
e
holes where the cable and three screws will be fastened.
Drill holes at these marks.
r
Install the mounting base using the supplied screws, as
t
shown below.
Gasket
Cap
Mounting base
Nut
Screw holes
(approximately 2 mm;
3
⁄
32
˝ (d))
The completed installation should look like this.
y