INTRODUCTION
DANGER
ORDERING PARTS
REPAIR NOTES
This service manual describes the latest service information
for the
IC-M32
VHF MARINE TRANSCEIVER at the time of
publication.
NEVER
connect the transceiver to an AC outlet or to a DC
power supply that uses more than 10 V. This will ruin the
transceiver.
DO NOT
expose the transceiver to rain, snow or any liquids.
DO NOT
reverse the polarities of the power supply when
connecting the transceiver.
DO NOT
apply an RF signal of more than 20 dBm (100mW)
to the antenna connector. This could damage the transceiv-
er’s front end.
Be sure to include the following four points when ordering
replacement parts:
1. 10-digit order numbers
2. Component part number and name
3. Equipment model name and unit name
4. Quantity required
<
SAMPLE ORDER
>
1110003200 S.IC
TA31136FN
IC-M32
MAIN UNIT
1 piece
8930060730
2691 keyboard
IC-M32
Chassis
5 pieces
Addresses are provided on the inside back cover for your con-
venience.
1. Make sure a problem is internal before disassembling the transceiver.
2.
DO NOT
open the transceiver until the transceiver is disconnected from its power source.
3.
DO NOT
force any of the variable components. Turn them slowly and smoothly.
4.
DO NOT
short any circuits or electronic parts. An insulated turning tool
MUST
be used for all adjustments.
5.
DO NOT
keep power ON for a long time when the transceiver is defective.
6.
DO NOT
transmit power into a signal generator or a sweep generator.
7.
ALWAYS
connect a 40 dB to 50 dB attenuator between the transceiver and a deviation meter or spectrum analyzer when using
such test equipment.
8.
READ
the instructions of test equipment thoroughly before connecting equipment to the transceiver.
To upgrade quality, all electrical or mechanical parts and
internal circuits are subject to change without notice or oblig-
ation.
Model
IC-M32
Version
U.S.A.
S.E. Asia
Australia
Symbol
[USA]
[SEA]
[AUS]
AC adapter
BC-147A
BC-147E
BM-95V
TX high power
5W
