![background image](http://html.mh-extra.com/html/icom/ic-g86/ic-g86_advanced-manual_612690033.webp)
8
SET MODES
8-7
Microphone simple mode
Microphone Simple mode is used to assign the
essential operations to the four switches (S1 to S4) on
the remote control unit.
(Default: mS .n1)
• mS .Sm
S1
—
S2 Turns the Monitor function ON or OFF.
S3 Selects channel 001.
S4 Selects channel 002.
• mS .n1
S1
—
S2
—
S3 Channel up.
S4 Channel down.
• mS .n2
S1
—
S2 Turns the Monitor function ON or OFF.
S3 Channel up.
S4 Channel down.
Initial Set mode items
User remote control unit
The circuit illustrated below is for only reference.
2.7 kΩ
6.8 kΩ 15 kΩ
33 kΩ
+
–
S1
S2
S3
S4
to the [SP] jack
GND
SP
REMOTE
Rated input 700 mW (8 Ω)
EXTERNAL SPEAKER
3.5(d) mm
>
‗
Voltage Indication
The voltage of the battery is displayed at power ON.
This display can be turned ON or OFF.
(Default: VLt.On)
• VLt.OF: The battery voltage display is skipped.
• VLt.On: The battery voltage is displayed at power
ON.
Battery protection function
When the battery voltage decreases, the Battery
Protection function automatically turns OFF the
transceiver. Select the function option according to
your battery type.
(Default: Differs depending on the transceiver version)
• bAt.OF: Turns OFF the function. Select when you
use the BP-263 battery case.
• bAt.nm: Select when you use the BP-264 Ni-MH
battery pack.
• bAt.LI: Select when you use the BP-298/BP-299
Li-ion battery pack.
NOTE: BE SURE
to select an appropriate option
according to your battery type.
Auto low power
Turns the Automatic Low-power function ON or OFF.
When the temperature goes below 0°C (+32°F), the
function automatically sets the output power to low. In
that case, the transmit power selections (High or Mid)
are also disabled.
(Default: ALP.OF)
• ALP.OF: The auto low power is OFF.
• ALP.On: The auto low power is ON.
NOTE:
This item is activated when the Battery
protection function is set to “bAt.nm” or “bAt.LI.”
CTCSS burst
The CTCSS burst function stops transmitting a
subaudible tone before your transceiver stops
transmitting RF, to eliminate noise. The CTCSS burst
will be effective only when the other station uses the
tone squelch function.
(Default: Sqb.OF)
• Sqb.OF: The CTCSS burst is OFF.
• Sqb.On: The CTCSS burst is ON.
Memory CH Overwrite
Select whether or not to overwrite the original memory
contents when charging the operating channel content.
(Default: mOW.On)
• mOW.OF:
The memory CH overwrite is OFF.
• mOW.On:
The memory CH overwrite is ON.
NOTE:
The original memory contents are the
following contents.
• Output power
• Tone function
• Subaudible tone frequency
• Tone squelch frequency
• DTCS code
• DTCS polarity
• Mode