1. Remove top and bottom covers of the repeater.
2. Remove cover for RX unit (located in top
compartment of repeater).
ANTENNA RELAY INSTALLATION for FR3000/FR4000 Repeater
TX UNIT
RX UNIT
RX UNIT
RX ANT
J1
3. Remove RX antenna cable (W12) from J-1 on
the RX Unit circuit board.
4. Completely remove N-type “RX” bulkhead
connector from rear of chassis.
5. Re-route cable (W12) from N-type connector
in a manner that the N-type connector end
is loose in the duplexer compartment of the
repeater, and the plug end if this cable will be
plugged into J-1 of the RX Unit.
6. Mount the Relay to the mounting plate
(included in Antenna Relay KIT).
7. Cover the hole where the “RX” bulkhead
connector was installed with the plastic
cap (included in Antenna Relay KIT).
Summary of Contents for IC-FR3000 Series
Page 4: ...6947 Count on us...
