5
2
PANEL DESCRIPTION
2
o
10-KEYPAD
(IC-F70DT/F70T or IC-F80DT/F80T only)
The keypad allows you to enter digits to:
• Select memory channels, tone channels and DTMF codes (dur-
ing transmission).
• Set TX codes and BIIS status number.
• Input text message for SDM operation.
• Start up with a password.
• Input the Individual ID code for digital operation.
!0
MONITOR SWITCH
➥
Mute and release the CTCSS (DTCS) or 2-tone squelch
mute. Open any squelch/deactivate any mute while
pushing and holding this key. (LMR operation only)
➥
Activates one of (or two of) the following functions on
each channel independently.
(PMR or BIIS PMR operation only)
• Push and hold the key to unmute the channel (audio is
emitted; ‘audible’ condition).
• Push the key to toggle the mute and unmute conditions
(toggles ‘audible’ and ‘inaudible’).
• Push the key to mute the channel (sets to ‘inaudible’ only).
• Push the key to unmute the channel (sets to ‘audible’ only).
• Push the key after communication is finished to send a ‘reset
code.’
• Push the key after communication is finished to send a ‘clear
down code’ during BIIS operation on a BIIS channel.
NOTE:
The unmute condition (‘audible’ conditions)
may automatically return to the mute condition
(‘inaudible’ condition) after a specified period.
• Desired function can be programmed by your dealer. (p. 7)
!1
PTT SWITCH [PTT]
➥
Push and hold to transmit; release to receive.
➥
Push to transmit the call during BIIS operation, depend-
ing on the setting.
!2
UP/DOWN SWITCHES
➥
Push to select an operating channel.
➥
Push to select a TX code channel after pushing
[TX CODE CH SELECT].
➥
Push to select a DTMF channel after pushing [DTMF].
➥
Push to select a scan group after pushing and holding
[SCAN].
➥
Push to select a BIIS code, status number or SDM
(Short Data Message) after pushing [DIGITAL].
• Desired functions can be programmed independently by your
dealer. (p. 7)
IC-F70_F80-1.qxd 05.1.18 4:26 PM Page 5 (1,1)