5 - 1
Microsoft, Windows and Windows Vista are registered trademarks
of Microsoft Corporation in the United States and/or other coun-
tries.
SECTION 5. ADJUSTMENT
PROCEDURE
SYSTEM REQUIREMENTS
• Microsoft
®
Windows
®
98/SE/ME/2000/XP
• RS-232C/USB port
BEFORE STARTING SOFTWARE ADJUSTMENT
Clone adjustment freqencies, TX power, CTCSS frequency, DTCS code and IF bandwidth into the transceiver using the
CS-F3011/F3013
CLONING SOFTWARE
before starting adjustment.
CAUTION!:
BACK UP the originally programmed memory data in the transceiver before programming the adjustment
frequencies. When program the adjustment frequencies into the transceiver, the transceiver’s memory data will be
overwritten and lose original memory data at the same time.
5-1 PREPARATION
¤
REQUIRED EQUIPMENTS
EQUIPMENT
SPECIFICATION
EQUIPMENT
SPECIFICATION
Adjustment
software
"CS-F3010 ADJ" (Revision 1.0 or later)
JIG cable
(see the page 5-3)
Modifi ed OPC-478U/UC (USB type) or
OPC-478 (RS-232 type)
Audio generator
Frequency range
: 300–3000 Hz
Output level
: 1–500 mV
Attenuator
Power attenuation : 30 dB
Capacity
: More than 6 W
RF power meter
(terminated type)
Measuring range
: 1–10 W
Frequency range
: 100–300 MHz
Impedance :
50
Ω
SWR
: Less than 1.2 : 1
Standard signal
generator (SSG)
Frequency range : 0.1–300 MHz
Output level
: 0.1 µV to 32 mV
(–127 to –17 dBm)
Frequency counter
Frequency range
: 0.1–300 MHz
Frequency accuracy : ±1 ppm or better
Input level
: Less than 1 mW
AC Millivoltmeter
Measuring range : 10 mV to 10 V
Oscilloscope
Frequency range : DC–20 MHz
Measuring range : 0.01–20 V
Modulation
analyzer
Frequency range
: 30–300 MHz
Measuring range
: 0 to ±10 kHz
External speaker
Input impedance
: 8
Ω
Capacity
: More than 1 W
¤
ADJUSTMENT CHANNEL SETTING
q
Using the CS-F3011/F3013
CLONING SOFTWARE
, create the cloning data for adjustments as shown below.
w
Clone the data file into the transceiver.