18
2
16
15
14
13
12
11
10
9
8
7
6
5
4
3
1
BASIC OPERATION
2
■
Setting the Ringer level
These instructions are for the non-display type transceivers.
The Ringer level can be adjusted between 1 and 5, or 1
(Linked) and 5 (Linked). When a Linked option is selected,
the ringer audio level is adjustable by rotating
[VOL].
Rotate
q
[VOL] to turn OFF the transceiver power.
Set
w
[ROTARY SELECTOR] to Channel 16.
While holding down
e
[Lower], rotate [VOL] to turn ON the
power and enter the Ringer level adjustment mode.
Push
r
[Upper] to increase, or push [Lower] to decrease
the Ringer level.
• Repeatedly pushing
[Upper] first selects 1 (lowest) to 5
(highest), and then selects the lowest linked level, 1 (Linked) to
the highest, 5 (Linked). Repeatedly pushing
[Upper] or [Lower]
repeats the cycle. See the illustration on the right.
• The adjustable range is 1 to 5 or 1 (Linked) to 5 (Linked).
• A beep sounds after pushing
[Upper]. Therefore, you can
determine the current level setting by the increasing loudness
of the beep that sounds.
• To determine if you have selected a linked level, set
[VOL]
to minimum, then push
[Upper] up to 10 times, listening for
the loudest beep (level 5). Pushing
[Upper] once after the
loudest beep will select 1 (Linked). Repeatedly push
[Upper]
or
[Lower] to select the desired linked level.
Rotate
t
[VOL] to turn OFF the power to exit the Ringer
level adjustment mode.
NOTE:
This operation may not be selectable, depending on the
presetting. Ask your dealer for details.
2
5
4
3
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)
Pushing
[Lower]
Pushing
[Upper]
[ROTARY SELECTOR]
[VOL]
[Upper]
[Lower]
