![background image](http://html2.mh-extra.com/html/icom/ic-f1000-series/ic-f1000-series_operating-manual_4189746020.webp)
17
BASIC OPERATION
2
■
Setting the Beep level
These instructions are for the non-display type transceivers.
The Beep level is adjustable between 1 and 5, or 1 (linked) and
5 (linked). When a Linked option is selected, the beep audio
level is adjustable by rotating
[VOL].
Rotate
q
[VOL] to turn OFF the transceiver.
Set
w
[ROTARY SELECTOR] to any channel other than
Channel 16.
While holding down
e
[Lower], rotate [VOL] to turn ON the
power and enter the Beep level adjustment mode.
Push
r
[Upper] to change the Beep level.
• Repeatedly pushing
[Upper] first selects 1 (lowest) to 5
(highest), and then selects the lowest linked level, 1 (Linked) to
the highest, 5 (Linked). Repeatedly pushing
[Upper] repeats
the cycle. See the illustration on the right.
• The adjustable range is 1 to 5 or 1 (Linked) to 5 (Linked).
• A beep sounds every time you push
[Upper]. Therefore, you
can determine the current level setting by the increasing loud-
ness of the beep that sounds.
• To determine if you have selected a linked level, set
[VOL] to
minimum, then push
[Upper] repeatedly, listening for the loud-
est beep (level 5). Pushing
[Upper] once after the loudest beep
will select 1 (Linked). Repeatedly push
[Upper] to select the
desired linked level.
Rotate
t
[VOL] to turn OFF the power to exit the Beep level
adjustment mode.
NOTE:
This operation may not be selectable, depending on the
presetting, Ask your dealer for details.
[ROTARY SELECTOR]
[VOL]
[Upper]
[Lower]
2
5
4
3
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)
Pushing
[Upper]