13
CONNECTOR INFORMATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
13-5
LAN
•Time synchronization by an NTP server.
•Outputs the demodulated signal or 12 kHz IF signal.
L
You can select the output signal from AF and IF
signals.
MENU
»
SET > Connectors >
LAN AF/IF Output
q
w
About the LED indication
q
LINK/ACT
•Lights when a cable is connected.
• Does not light when a cable is not
connected.
•Blinks while communicating.
w
Speed
•Lights while communicating in 100BASE-TX.
•Does not light while communicating.
• Blinks while communicating in 10BASE-T, or not
connected.
EXT-DISPLAY
Connects to an external display
monitor.
Outputs the digital RGB signal.
(DVI-D)
L
Set the external display settings on the following
screen.
MENU
»
SET > Display >
External Display
USB 2
USB (1.1/2.0/3.0) type B
This USB port is for digital data input or
output.
L
The required USB driver and driver’s installation
guide can be downloaded from Icom web site.
USB 1
MENU
»
SET > Connectors >
USB Output Select
MENU
»
SET > Connectors >
USB AF Output Level
MENU
»
SET > Connectors >
USB IF Output Level
USB (1.1/2.0) type B
Connect to the PC when:
• Outputting the decoded FSK (RTTY) data.
• Outputting the demodulated AF signal or
12 kHz IF signal.
• Interface for the remote control by the
CI-V command.
L
You can change the signal output type and output
level.
L
You can download the USB driver and installation
guide from the Icom website.
http://www.icom.co.jp/world/support/download/firm/
index.html
EXT-SP A / EXT-SP B
Connects to external speakers.
3.5 mm, ⅛ in (d)
•
Output impedance: 4 ~ 8 Ω
•Output level:
More than 2.0 W at 10%
distortion into an 8 Ω load.
Information
L
• The internal speaker is deactivated while an
external speaker is connected.
• [EXT-SP A] is for the Main band and [EXT-SP B] is
for the Sub band.
REF IN
Inputs a 10 MHz signal as a reference frequency
signal.
•Input frequency:
10 MHz
•
Impedance:
50 Ω (unbalanced)
•Input level:
–10 dBm (approximate)
L
Select the transceiver’s reference signal source.
MENU
»
SET > Connectors >
REF IN
L
Adjust the internal reference frequency.
MENU
»
SET > Function >
REF Adjust
