![background image](http://html2.mh-extra.com/html/icom/ic-7610/ic-7610_basic-manual_4141367057.webp)
8
SET MODE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
8-5
Connectors
MENU
» SET > Connectors >
Phones
Level
(Default: 0)
Sets the audio output level ratio of the headphone and
internal speaker between -15 and +15.
L/R Mix
(Default: OFF)
Selects to output the mixed audio from the headphones
or to output the Main band’s audio from the leftside and
the Sub band’s audio from the rightside.
MENU
» SET > Connectors >
ACC AF/IF Output
AF/SQL Output Select
(Default: MAIN)
Selects the audio and squelch signals to output from
[ACC1] (Audio: pin 5, Squelch: pin 6) in the Main and
Sub bands.
Output Select
(Default: AF)
Selects AF signal or IF signal to output from [ACC].
AF/IF XFC Output (SPLIT ON)
(Default: SUB)
Selects the signal output from [ACC1] while
XFC
is
held down in split operation.
AF Output Level
(Default: 50%)
Sets the AF output level of [ACC].
AF SQL
(Default: OFF (Open))
Selects whether or not to output the audio from [ACC],
according to the squelch state.
AF Beep/Speech... Output
(Default: OFF)
Sets the Beep and Speech audio output setting of
[ACC].
L
You should set the “AF SQL” item to “AF.”
L
The beep level is limited when the “Beep Level Limit”
item is “ON.”
ACC IF Output Level
(Default: 50%)
Sets the IF output level of [ACC].
MENU
» SET > Connectors >
USB AF/IF Output
Output Select
(Default: AF)
Selects the signal output type from [USB1].
AF/IF XFC Output (SPLIT ON)
(Default: SUB)
Selects the signal output from [USB1] while
XFC
is
held down in split operation.
AF Output Level
(Default: 50%)
Sets the AF output level of [USB1].
AF SQL
(Default: OFF (Open))
Selects whether or not to output the audio from [USB],
according to the squelch state.
AF Beep/Speech... Output
(Default: OFF)
Sets the Beep and Speech audio output setting of
[ACC].
L
You should set the “AF SQL” item to “AF.”
L
The beep level is limited when the “Beep Level
Limit” item is “ON.”
IF Output Level
(Default: 50%)
Sets the IF output level of [USB].
MENU
» SET > Connectors >
LAN AF/IF Output
Output Select
(Default: AF)
Selects the signal output type from [LAN].
AF SQL
(Default: ON)
Selects the squelch behavior of [LAN].
MENU
» SET > Connectors >
MOD Input
ACC MOD Level
(Default: 50%)
Sets the modulation input level of [ACC].
USB MOD Level
(Default: 50%)
Sets the modulation input level of [USB].
LAN MOD Level
(Default: 50%)
Sets the modulation input level of [LAN].
DATA OFF MOD
(Default: MIC,ACC)
Selects the connector(s) to input the modulation signal
when the data mode is OFF.