Icom F6220D 16 USA, Instruction Manual

Page: 10 / 24

6
2
BASIC OPERATION
Turning ON the power
■
Push
q
[ ]
to turn ON the power.
If the transceiver is programmed for a start up password,
w
input the digit codes that were set by your dealer.
• The keys shown below can be used for password input:
The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are the same.
KEY
NUMBER
0
5 4
9 3
8 2
7 1
6
If the “PASSWORD” indication does not clear after input-
e
ting 6 digits, the input code number may be incorrect. Turn
OFF the power and re-enter your password.
Channel selection
■
There are several ways to select channels, and they may dif-
fer, depending on your system set up.
NON-ZONE TYPE:
To select the desired operating channel:
Push [CH Up] or [CH Down].
➥
Push one of [MR-CH 1] to [MR-CH 4].
➥
ZONE TYPE:
To select the desired operating channel:
Push [Zone], then push [CH Up] or [CH Down].
➥
VOTING OPERATION:
The transceiver automatically starts scanning when a zone,
specified for the voting operation, is selected.
The voting scan detects the S-meter of the repeater and au-
tomatically selects the strongest station.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
ON the power, the transceiver automatically starts scanning.
Scanning stops when a signal is detected.