0
I C O M
OPERATING GUIDE (for IC-207H)
GETTING STARTED
Before using the program, make a backup copy of
To use this program, the following hardware and
the original disk. Operate the program using the
ba
software are required:
and keep the original in
a
safe
p/ace.
l
IBM PC/AT or
compatible computer with an
RS-232C serial port
This cloning program is designed to perform data
setting and cloning for the dual band transceiver
IC-207H.
l
MS-DOS, PC-DOS or IBM DOS ver. 5.02 or higher
. OPC-646 CLONING CABLE
CONNECTIONS
I
cloning operations are performed from
computer’s keyboard including power ON
only connect to a DC power supply is needed
the transceiver.
female plug
IC-207H
level converter circuit)
Personal
computer
-646 Cloning cable
be purchased separately)
INSTALLATION AND PROGRAM START UP
n
Installation and initial setup’
Connect the transceiver and
PC as above
then con-
nect a
DC power supply to the the transceiver.
To install the CS-207 cloning software to
directory of drive C while the program
disk is in drive A, type as follows at the DOS prompt:
A : \ I N S T A L L
A:
[Enter]
Program drive
Target drive/directory
A target directory is created if it does
already
exist; CS-207 cannot be installed to the root directory.
After the installation is finished, the CS-207 initial
setup screen appears and the transceiver model is
checked. Proceed as follows:
Select the connected RS-232C
port with the [
and [Enter] keys.
Input your call sign then push [Enter].
After the initial setup, CS-207 is automatically
launched. Set or modify the data as desired.
l
See the back page for operation.
the File sub menu to save the data or to exit
the program.
To start the program after installation, operate as
n
Starting the program
follows at the DOS prompt:
Change to the installed directory.
l
in case of the example at left.
Type as follows to start:
[Enter]
(at the installed directory)
n
Operating from a floppy disk
This program can be operated from a floppy disk.
Insert the backup disk into the floppy disk drive.
Select the floppy disk drive as the current drive.
Select the
directory.
Type
then push [Enter] to start.
NEVER
remove
the
program
disk from the floppy disk
drive while the program is running.
NEVER set the floppy disk as write-protected.
Cloning will take 20 sec. or more when operating from a
Portions of this software are copyrighted by Microsoft Corporation.
MS-DOS is a Microsoft trademark.
- - - - -
, . - . . - - -
