To Install Thermostat (continued)
2.. To.remove.cover,.insert.and.twist.a.coin.or.screwdriver.in.the.slots.on.the.sides.of.the.thermostat.
3.. Put.thermostat.base.against.the.wall.where.you.plan.to.mount.it.(Be.sure.wires.will.feed.through.the.
wire.opening.in.the.base.of.the.thermostat).
4.. Mark.the.placement.of.the.mounting.holes.
5.. Set.thermostat.base.and.cover.away.from.working.area.
6.. Using.a.3/16”.drill.bit,.drill.holes.in.the.places.you.have.marked.for.mounting.
7.. Use.a.hammer.to.tap.supplied.anchors.in.mounting.holes.
8.. Align.thermostat.base.with.mounting.holes.and.feed.the.control.wires.through.wire.opening.
9.. Use.supplied.screws.to.mount.thermostat.base.to.wall.
10.. Insert.stripped,.labeled.wires.in.matching.wire.terminals..See.“Wiring.Diagrams”.section.of.this.
manual.(Pages.5.to.18)..If.using.optional.remote.sensor,.see.“Remote.Sensor.Installation”.(Page.4).
.
CAUTION!
:.
Be.sure.exposed.portion.of.wires.does.not.touch.other.wires.
11.. Tighten.screws.on.terminal.block..Gently.tug.wire.to.be.sure.of.proper.connection..Double.check.that.
each.wire.is.connected.to.the.proper.terminal..
12.. Seal.hole.for.wires.behind.thermostat.with.non-flammable.insulation.or.putty.
13.. Replace.cover.on.thermostat.by.snapping.it.in.place.
14.. Turn.on.power.to.the.system.at.the.main.service.panel.
15.. Test.thermostat.operation.as.described.in.“Testing.the.Thermostat”.(Page.23).
