GC-76/GC-106 GAS LEAK DETECTION CORE USER MANUAL
8
3.
Safety Information
•
Operation is subject to the following two conditions: 1 This device may not
cause harmful interference, and 2 this device must accept any interference
received, including interference that may cause undesired operation.
•
This device must be installed by qualified service personnel or system
installation personnel.
•
Do not disassemble or modify the thermal device.
If the device operates
abnormally, please contact the supplier and do not dismantle the device
on your own.
•
Do not point the imager (with or without the lens cover) at intensive energy
sources, e.g. devices that emit laser radiation, or the sun. This can affect
the accuracy of the camera, and cause damage to the detector.
•
Do not use the imager in temperatures higher than 50 °C (122 °F) or lower
than -15 °C (5 °F). High/low temperatures can cause damage to the device.
•
Do not cut, alter, or place heavy items on the device. These actions may
cause an electric short leading to fire or electrocution.
•
Prior to start of the device, make sure that the power supply is properly
connected. If the power supply is connected incorrectly, the device may
be damaged.
•
Do not put holes in the device with objects. Damage to the device may occur.
•
Do not hit the device with a hammer or apply strong impacts or electric
shocks to it. Damage to the device may occur.
•
Do not put the device in or near a fire, stove or other high-temperature
locations. Damage or ignition of the device may occur.
•
Do not put the device in direct sunlight or other high-temperature locations.
Damage or ignition of the device may occur.
•
Do not get water or salt water on the device or permit the device to get
wet. Damage to the device may occur.
•
Remove any water or moisture on the device before you install it. Damage
to the device may occur.
•
If there are fluids on the device and the fluid gets into the eyes, do not rub
the eyes. Flush well with water and immediately get medical care.
•
Always dispose of device in accordance with local, state and federal
regulations.
•
Do not use the device if, when used, there is a smoke emitted from the
device, the device feels excessively hot, changes color, changes shape, or
is in an unusual condition. Speak with a sales office if one or more of these
problems occurs.
•
Do not use liquids to clean the electronics.
•
Clean the case with a damp cloth and a weak soap solution. Do not use
abrasives, isopropyl alcohol, or solvents to clean the case or lens/screen.
