ICI STEP INSTALLATION
STEP
8
(
Tighten
Brackets to the Bar
)
Once the
3
brackets are fully
tightened to the truck,
adjust
the bar from front to back and
tighten the bar to the brackets
with a 13mm socket and
provided Allen
wrench
. Make
sure the bar is flush with the
front and bottom face of the
brackets as you are tightening
them. Then, tighten the Hoop
Steps to the bar.
STEP
9
(
Finish
)
Check all hardware and
make sure they are fully
tightened. Reference
diagram on page 3 for
hardware locations. Repeat
Steps 1-
9
for the Passenger
Side
.
0
6
Figure
9.
0
7
STEP
7
(
Tighten
Brackets to Truck
)
Make sure all
3
brackets
are
loosely
fit to the vehicle and bar.
Using a 13mm socket, fully
tighten the front bracket to the
vehicle. Make sure the bracket is
flush with the mounting surface.
Repeat on the middle and rear
bracket
s,
checking the bracket
alignment as needed.
Leave bar
loose for now.
www.facebook.com/InnovativeCreationsInd
www.instagram.com/ici_usa
Hashtags:
#ICIUSA
#ICIAlumilite
#AlumiliteSteps
#AlumiliteBumpers
Figure
7
.
Figure
8
.
TAG ICI ON SOCIAL MEDIA
*PRO TIP:
When tightening the Finish Washers, hold the Allen Key tight so the Bolt does not spin.
Then, tighten the Nut on the backside.
This will prevent the Bolt and Finish Washer from spoinning and scratching the Bar.
AMAZING
!
You have successfully completed the
installation
of your new Alumilite s
teps
.
Time
to flex on your friends through
Social Media! Don't forget to Tag us!
Drop us a Review!