ICI STEP INSTALLATION
Step 1 (Prep)
Beginning on the Driver's side,
remove any steps if equipped.
Next, locate the
3
sets of
mounting points on the
underside of the vehicle (Fig. 1).
Underneath the rocker panel,
there are three bracket
locations, each location has
three OE Factory bolts
protruding out.
ICI STEP INSTALLATION
Figure 1.
Step 3 (Hang bar
on Brackets)
Next, locate the driver side bar
.
T
he
front tip of
each bar is
sloped down to follow curve of
door
.
Reference diagram on
page 3.
The top of the bar has
a
small lip, use the lip to hang
the
bar on the brackets. This
will
make the installation
process
easier and hands-free.
Figure 6.
Figure 5.
04
05
Figure 2.
Step 2 (Install
Brackets to
Truck
)
Begin with the driver front bracket
1005
40
.
You will need
(
3
sets)
of
M8
nylock nuts and
M8
flat
washers
.
Use a 13mm socket
and
do not fully tighten yet. Once the
front bracket is attached, move
on to the middle
and rear
bracket
s
,
repeating the steps
above
for each bracket
.
Figure
4.
Figure
3
.
Step 4 (Bolt
Front
B
racket
to Bar)
Start by bolting the
front
bracket to the bar.
It is the
1st
bolt hole from the front.
You
will need
(2 sets)
of M8
nylock
nuts
,
M8x3
5
mm
hex
countersunk bolts
, M8 flat
washers, and M8
finish
washers. Use a 13mm wrench
and the provided Allen
wrench. Do not fully tighten
until all brackets and steps
have been attached.
Step 5 (Bol
t
Middle
Bracket to Bar and
Front Hoop Step
)
Next, bolt the
middle
bracket to
the bar
and front hoop step
.
Note that the bracket and hoop
step share a bolt.
You will need
(
3
sets)
of M8 nylock nuts,
M8x3
5
mm
hex countersunk
bolts
, M8 flat washers, and M8
finish washers.
Use a 13mm
wrench and the provided Allen
wrench.
Reference diagram on
page 3
.
Do not fully tighten
yet.
Step 6 (
Bolt
Rear
Bracket to Bar and
Rear
Hoop Step
)
Then,
bolt the rear bracket to
the bar and frear hoop step.
Note that the bracket and hoop
step share a bolt. You will need
(3 sets) of M8 nylock nuts,
M8x35mm hex countersunk
bolts, M8 flat washers, and M8
finish washers. Use a 13mm
wrench and the provided Allen
wrench. Reference diagram on
page 3. Do not fully tighten yet.