17
5.6
DOOR
5.6.1 DOOR OPENING
The door is adjusted in the factory with
standard opening to the left (s)
and with
hinges on the right (d)
.
CAUTION: it is dangerous to unscrew the ring nuts (8d) on the side of the hinges to avoid
causing the door to detach, with possible serious damage to people and property.
5.6.2 DOOR OPENING REVERSAL (TO THE RIGHT)
Only for models listed in the Technical Data table
Proceed as follows to reverse the opening direction of the door:
Door with ferrules perforated on both sides
1.
Screw the left perforated ferrules
(8s) so that the door seal gasket is pressed in the same way as the
right part. Bring the conical washers (10s) of the left tie-rods close to the mechanical tubes (9s) of the
door and tighten the nuts (7s) using a suitable wrench.
2. On the right opening side, loosen the nuts (7d) and free the conical washers (10d) from the mechanical
tubes (9d) of the door.
Door with wrench ferrules, hinge side
IMPORTANT NOTE: In models equipped with wrench-adjustable ferrules (8d), these must always be
mounted on the hinges to prevent the door from being accidentally opened through the lever (12).
In this case, proceed as follows:
3. Proceed as indicated in point 1.
4. Cross-change the wrench ferrule of a hinge (8d) with the opposite perforated ferrule (8s), after loosening
the locking nuts on the tie rods and freeing the conical washers.
5. On the left hinge side, fasten the conical washer (9s) onto the door using the nut (10s).
6. Proceed with the other two ferrules following the procedure described in points 4 and 5.
CAUTION: When cross-changing ferrules, always make sure that the other two ferrules
are fastened, so that they hold the door.
7. Check the correct adjustment of the tie-rods and hinges ensuring that, during closure, the seal gasket is
evenly pressed in the centre on the whole circumference
(see figure).
If necessary, adjust as described in the next par.
Summary of Contents for GREENOx.e Series
Page 31: ......
