31
3. Cleaning and sterilizing
Distill 74ml(12.5 fl.oz) of 5.25% sodium hypochlorite solution(for whitening) with 19L(642.5 fl.oz)
of warm water.
(Refer to the user manual of the solution as the ratio may vary per manufacturer).
This is the minimum ratio - increase the ratio of the solution as needed.
※ Distilled cleaning solution must be used immediately to ensure maximum effect and safety.
4. Sterilizing procedure - Early steps
1) Block water supply by closing the water valve, turn off the power switch and circuit breaker
and check if the power cord is unplugged and disassemble the top and front panels.
2) Unscrew 5 knobs from the ice suite assembly and lift up to remove it and remove the rubber
O-ring and nylon O-ring.
3) Pour the sterilizing solution to the ice outlet head until the evaporator assembly and water tank are full.
(Up to the point that the solution overflows from the drain fan)
4) Remove the proximity switch from the storage tank controlling assembly.
5) Remove 2 butterfly nuts from the suite fixing bracket and suite inlet guide to disassemble all parts.
Remove the insulation from the bottom of ice suite(3 strings and insulation).
6) Remove 6 butterfly nuts and disassemble ice suite guide panel and plastic fixing panel.
7) Remove 2 butterfly nuts from the top of the ice suite, and then lift the storage tank controlling
assembly while removing the support bracket by unscrewing 1 fixing screw from the back.
8) Remove 2 snap pins from storage tank controlling assembly and disassemble the shaft and actuator.
9) Clean and sterilize suite inlet guide, rubber O-ring, nylon O-ring, rubber packing, suite fixing bracket,
drip guide, ice suite, ice suite guide panel, plastic fixing panel, storage controlling assembly
and supporting bracket.
10) Completely rinse all parts with clean water
(※ Any remaining cleaning solution will cause corrosion).
11) Make sure that all parts are assembled in correct places.
(※ Ice suite guide panel must be assembled so that ice cubes will be led to the inside(front of the actuator).
12) Plug the power cord to the outlet, turn on the circuit breaker and set the power switch
to 'ICE' until sterilizing solution is drained and ice making stops.
13) Set the power switch to 'DRAIN' to drain water for 5 minutes.
14) Turn off the power switch and circuit breaker and unplug the power cord.
5. Sterilizing procedure - Last steps
1) Make a new batch of sterilizing solution in a new container.
2) Block water supply by closing the water valve, turn off the power switch and circuit breaker
and check if the power cord is unplugged and disassemble the top and front panels.
3) Unscrew 5 knobs from the ice suite assembly and lift up to remove it..
4) Pour the sterilizing solution to the ice outlet head until the evaporator assembly and water tank are full.
(Up to the point that the solution overflows from the drain fan)
5) Insert the suite inlet guide of ice suite assembly at the correct location and screw 5 knobs
to fix the assembly.
6) Leave the ice maker for 10 minutes before operating it.
7) Plug the power cord to the outlet, turn on the circuit breaker and set the power switch
to 'ICE' until sterilizing solution is drained and ice making stops.
8) Set the power switch to 'DRAIN' to drain water for 5 minutes.
9) Set the power switch to 'ICE' and open the water supply valve to fill the tank with water.
10) Set the power switch to 'OFF' when the gear motor starts running.
11) Set the power switch to 'DRAIN' to drain water for 5 minutes.
12) Set the power switch to 'ICE' and make ice cubes for 30 minutes then set the switch back to 'OFF'.
13) Pour warm water into the ice tank to melt the cubes and drain water, then clean the tank
with mild detergent. Make sure to rinse the tank with clean water.
