Icera S1201, Installation & User Manual

Page: 18 / 22

16
TROUBLESHOOTING GUIDE
ISSUE POSSIBLE CAUSES SOLUTION
Seat does not work at all.
The seat sensor is covered by cloth
or any other object. Sensor must be
activated by skin contact in order for
most functions of the seat to work.
Remove any fabric or object blocking
the seat sensor.
Plug is loose or poor connection. Make sure the plug is securely
plugged into the outlet.
The power indicator light is off. If the power indicator light is off,
press the stop button on the remote
or side panel to turn the unit back on.
Power is out. This seat is fully electronic. Power
must be on in order for seat to work.
Spray functions not
working.
Filter is clogged. Clean the filter. See page 15 for
instructions.
Spray pressure is not
strong enough.
Water pressure is set at lowest level. Increase the water pressure using the
remote control.
Filter is clogged. Clean the filter. See page 15 for
instructions.
Nozzle is clogged or dirty. Clean the nozzle. See page 15 for
instructions.
Spray is not warm
enough.
Water temperature is set at lowest
level.
Increase the water temperature using
the remote control.
Seat is not warm.
Seat temperature is set at lowest
level.
Increase the seat temperature using
the remote control.
Remote control is not
working.
Batteries are dead or inserted
incorrectly.
Check that the batteries are inserted
correctly and test. Replace if
necessary.
Seat is unoccupied. Most functions will not work if
the seat is unoccupied. Make sure
the seat sensor is being engaged.
See Parts Identification for sensor
location.
Remote is not properly paired with
the seat.
See page 17 for remote pairing
instructions.