=10=
Chapter
III Instrument Operation Instructions
After power on, first enter the welcome interface and then jump to the language selection interface.
Press the corresponding soft key to select the language and finally enter the main interface. After
you turn on the computer again, you do not need to repeat the language selection and go directly to
the main interface.
1. Set the parameters in the main interface and output waveform
➢
Press
button to turn the output on or off simultaneously for both channels.
➢
Output channel selection: The front panel
,
keys are used to switch the currently
selected channel (CH1 or CH2). Pressing
,
keys again in the currently selected
channel can turn on/off the output of the channel, and long press to place the current channel
on the main display of the screen. (upper part).
➢
Set the waveform: press the front panel
key to activate the waveform switching of the
current channel. In the active state of the waveform, the knob can be quickly switched, and the
direction key
can be used to quickly switch between the arbitrary waveform and the
preset waveform.
➢
Set Frequency: Press the soft key
to highlight the “Frequency” parameter. At this time, use
the direction keys
to move the cursor to select the bit to be edited. Then turn the
knob to change the value. Press and hold the soft key
to change the frequency unit (MHz,
KHz, Hz, mHz). , uHz).
➢
Press and hold the duty cycle, offset, and phase soft
－
keys to initialize to default values.
language selection