Icegame 3 Across, Service Manual

Page: 6 / 50

6
MARQUEE INSTALL INSTRUCTIONS
There are three different bonus marquees available for 3 Across. NA7010X is used mostly
for a single lane or when there is not enough height for the full size marquees NA7000X and
NA7001X. The NA7010X programming information is stored on the games’ main board
while both the NA7000X and NA7001X overrides any mini marquee programming informa-
tion and stores it’s information directly on the marquee. See programming information on
page 9 and 10 for details.
NA7010X
Bonus Marquee Install
The marquee comes with two harnesses which need to be installed along with mounting the
marquee onto the cabinet. One harness is a AC splitter that connects between the curly bulb
power plug found up top and the other is the communication cable which connects to the
main board. Turn game off and unplug before starting. Begin by removing the plastic
header panel and sliding the display mounting assembly up and out. There should be
enough slack to rest the display mounting assembly on top of the game. See page 11
through 13 for diagrams. Connect the ac between the ac coming from below and the curly
bulb. Be sure to reconnect the curly bulb’s ac. Replace the display mounting assembly back
into the cabinet and the plastic header panel. Connect the communication harness and
mount the marquee with the supplied hardware. Run the communication cable on top of the
cabinet, down the back, through the bottom following the rest of the harnesses back to the
main board. Connect the harness into J2 on the main board. See full wiring diagram insert
for detail information. See diagram on next page for mounting diagram.
NA7000X
Bonus Marquee Install
The marquee is shipped in two sections, a large display marquee and a smaller display mar-
quee. This marquee assembly is to be positioned centered to all linked games. See picture
shown below for example. Begin the install by mounting the larger display first, then the
smaller display underneath. See diagrams below for details. Un-tie the grey cable coiled be-
hind the upper marquee and connect this to the smaller marquee, see diagram below. Plug
the AC cord and run that down the back and into a AC outlet. Connect the phone cable to
the upper marquee and at either end of set of linked games, follow the wire harnesses back
to the main board and into any free link connection.
To program the marquee press, on any linked lane, SW5. This will put the marquee in pro-
gramming mode. Now use select and advance to change the settings on the marquee. Re-
member, the marquee has additional audio and therefore has it’s own volume control inde-
pendent from the main games.
NA7001X
Bonus Marquee Install
The marquee is the same as NA7000X except for the AC harness. If you have purchased
the game with this option at the same time, one unit will have a “Left” sticker located on the
back of the cabinet. This cabinet located in the upper header area has a 220 to 110 step
down transformer. This is where you would plug in the AC harness instead of a AC outlet as
described above. If you purchased this option separate a 220 to 110 step down transformer
is included and will need to be mounted inside the header area before mounting the mar-
quee.