Ice SCRUB 35C, Use And Maintenance Manual, Page: 21 / 28

21 21
WEEKLY MAINTENANCE
1. REPLACING THE REAR SQUEEGEE RUBBERS
Check the state of wear and tear of the rear squeegee rubbers
The rubbers should be considered worn when their profile is no longer linear (when cuts or wear can be
seen on the edge). In this case, replace them.
To replace it you must:
1.
Raise the rear squeegee
2.
Remove the two knobs
3.
disassemble the squeegee from its support
4.
Remove the tube from the squeegee nozzle so the squeegee can be removed
W ARNING: Before carrying out any type of maintenance,
disconnect the machine's battery connector.
W ARNING: this operation must be carried out by using gloves in
order to protect against contact with dangerous solutions
5.
Unscrew the knobs on the squeegee that block the rubber-pressing blades and remove them
6.
Remove the rubber-pressing blades
7.
Turn the rubbers upside down, or replace them
8.
Reassemble everything, carrying out the above-mentioned operations in the reverse order
WARNING: you are advised to always wear protective gloves in order to avoid
the risk of serious injury to your hands
2. REPLACING THE FRONT SQUEEGEE RUBBERS
Check the state of wear and tear of the front squeegee rubber
The rubber should be considered worn when its profile is no longer linear (when cuts or wear can be seen
on the edge). In this case, replace it.
To replace it you must:
1.
Raise the front squeegee
2.
Remove the two springs (A) and unthread the two fixing pins (B)
3.
Disassemble the squeegee from the supports
4.
Remove the tube from the squeegee nozzle so the squeegee can be removed
W ARNING: Before carrying out any type of maintenance,
disconnect the machine's battery connector.
W ARNING: this operation must be carried out by using gloves in
order to protect against contact with dangerous solutions