Ice i28BTL, Operator'S & Parts Manual

Page: 11 / 39

11 ICE i28BTL / i32BTL
OPERATOR MANUAL
FAULT CODE & SOLUTION
The machine is equipped with a LED display screen
(Panel components, item # 4), the LED screen will
display the operating hours (Panel components,
item # 17) and the battery level status (see Panel
components, item # 2).
When the machine detects a fault, there will be a
Fault code (Panel components, item #18) & Fault
message (Panel components, item #11) display
on the LED screen, and the Fault indicator (Panel
components, item #1) will flash continuously,
accompany an audible alarm Occasionally.
Once fault occuring, please DO NOT continue
operate the machine unless the fault are eliminated.
Turn off the machine, then to solve the fault, the
fault code & message will be eliminated when
machine restart.
If the fault is occurred frequently, or the fault can't
be eliminated, please contact ICE service center.
Please refer to the below table to determine the
fault cause and the solution.
FAULT
CODE
FAULT MESSAGE FAULT CAUSE SOLUTION
F03
Bru Actt O.L.
RESTART!
Scrub head lifting actuator is overload
Turn off the machine,after a moment,
RE-START machine.
F04
Vac Mtr O.L.
RE-START!
Vacuum motor overload
F05
Left Bru Mtr O.L.
RE-START!
Left brush motor is overload
F06
Right Bru Mtr O.L.
RE-START!
Right brush motor is overload
F07
Propel Mtr O.L.
RE-START!
Propel motor overload
F08 RecTank Full Recovery tank is full Drain the Recovery tank
F10
Batt Low
Charge Batt
Battery is low Charge the battery
F11
Batt Empty
Charge Batt NOW
Battery is empty Charge the battery NOW
F12 Brake Wiring Error Bad Brake wiring Check the brake wiring
F14 Replace Brake Assy Bad Brake assembly Replace the brake assembly
F16
Control Unit Overheat!
Wait
Control Unit Overheat
Turn off the machine,after a moment,
RE-START machine
F17 Replace Control Unit Control Unit Fault Replace the control unit
F20 Check Left Brush motor Bad left brush motor Check left brush motor/ wiring
F21 Check Vac Mtr Bad Vacuum motor or wiring Check the vacuum motor / Wiring
F22 Check Soln Solenoid Solution solenoid wiring fault Check the wiring & Contactors
F23 Replace Soln solenoid Bad Solution solenoid Replace the solution solenoid
F24 Check Propel Motor Bad propel motor Check the propel motor / Wiring
F25 Check Right Brush motor Bad right brush motor Check right brush motor/ wiring
F40 Check Proximity Sw Proximity switch fault Check the Proximity switch
F41 Release Handle Operation mistake Release the control handle bail
F42 Replace Control Unit Bad Control Unit Replace the control unit
F43
Turn Dead Sw Off
RE-START!
Emergency stop button activated
Release emergency stop button and
restart machine
F44 Replace Control Unit
Bad Control Unit
Contact service center, Replace the
Control Unit
F45 Return Control Unit
F46 Return Control Unit
F47 Return Control Unit
F48 Return Control Unit