Ice i28BTL, Operator'S & Parts Manual

Page: 10 / 39

10 ICE i28BTL / i32BTL
OPERATOR MANUAL
BatteRy cHaRGInG
WaRnInG: fire or explosion Hazard.
Keep Sparks and open flame away. Keep
Battery compartment propped open When
charging.
only use Ice supplied or approved batteries
charger, use unapproved charger may cause
damage to the batteries and machine.
Batteries chargers specifications:
• applicable to charging lithium-ion batteries
• automatic shut off circuit
• output current of 30 amps
• output voltage of 24 volts
1. Place machine in a well ventilated area.
2. Turn the machine off.
3. Connect the charger's AC power supply cord to
a properly grounded receptable.
4. Prop up the recovery tank by the support stand
(Machine components, item #20) for ventilation
when charging.
5. The charger will automatically begin to charge
and will automatically shut off once the batteries
are fully charged.
6. Upon completion of charging, disconnect the
AC power supply cord.
WaRnInG: Before performing any
maintenance on the machine, be sure that
the power is turned off, or the batteries are
disconnected!
WaRInG: Repairs are to be completed
by authorized service centers only. any repairs
completed by unauthorized persons will avoid
the warrenty.
daIly maIntenance
1. Remove pad driver/ brush and clean with
approved cleaner.
2. Drain recovery and solution tanks completely
and rinse out with clean water. Visually check
the recovery tank for debris and clean out as
necessary.
3. Raise the squeegee assembly off floor and wipe
it down with a damp towel. Be sure to store the
squeegee in the up position.
4. Remove the float shut-off assembly and rinse it
out with clean water.
5. Clean machine with an approved cleaner and a
damp towel.
6. Recharge the batteries.
7. Check the condition of the squeegee blade
wiping edge, rotate blade if worn.
montHly maIntenance
1. Clean the battery tops to prevent corrosion.
2. Check for loose battery cable connections.
3. Inspect and clean the recovery tank cover seal.
Replce it if damaged.
4. Lubricate all grease points and pivot points with
silicon spray and approved grease.
5. Check the machine for loose nuts and bolts.
Check the machine for leaks.
macHIne StoRaGe
1. Always store the machine indoors.
2. Always store the machine in a dry area.
3. Always store the machine in its upright position.
4. Always store the machine with the pad driver/
brush raised off the floor.
5. Always store the machine with the squeegee
assembly raised off the floor.
6. If storing in an area which may reach freezing
temperatures, be sure to drain all fluids from the
machine prior to storage. Any damage caused
by freezing temperatures will not be covered by
the warranty.
7. Drain the recovery tank.
8. Drain the solution tank of all fluid.
pReVentatIVe maIntenance