Ice I18B, Operator'S Manual

Page: 7 / 33

MACHINE SET UP & INSTALLATION
ICE I18B/I18C 7
OPERATOR MANUAL
UNPACK MACHINE:
Be sure and check packing carton for any damage. Immediately report any damage to carrier.
Be careful not to let machine vibrate while carrying, Check contents of package to ensure that
the following items are included: Machine, squeegee assembly, brush/pad driver, charger cord.
1) Sweep the outside of the machine.
2) Check battery meter to make sure batteries are fully charged (see battery charging, only for
I18B ).
3) Check that squeegee and brush / pad is properly installed.
4) The forward speed of machine can be controlled by turning the handle(10). Turn the handle
clockwise to speed up machine. or turn the handle anticlockwise to slow down machine.
?@J% J! %%!%%! %' Q
exceed the limit that machine allowed(2%).
INSTALLING THE SQUEEGEE:
1) Loosen the two knobs(18) on the squeegee and slide the squeegee into the slots at the rear
of the squeegee bracket. (the wheels on the squeegee point to the machine.)
2) Tighten the knobs securely.
MACHINE SET UP & PRE-OPERATION CHECKS:
INSTALLING PAD DRIVER OR BRUSH:
1) Turn off machine.
2) Tilt the machine backwards, line up the driving hub with the hole of brush or pad driver, make
%%$ J %% %#%$
Z#$!% % $% %#
3) Push the plunger which on the brush cover to prevent the driving hub from rotating,then spin
the brush/pad clockwise with your another hand till the clip clamp the block on the brush/pad.
FILLING THE SOLUTION TANK:
[@% % %%! %%
2) Fill solution tank with water. (use a hose which link to a water faucet,water temperature
should not exceed 50° C) The clear tube(19) in the back right of the machine has gallon
markers to help determine the water level in the solution tank(5).
*Depending on the dirty level of the ground, add the proper amount of detergent into the
solution tank.
Do not put any flammable materials into solution tank. This can cause an
explosion or a fire. Only use recommended cleaning chemicals. Contact
your janitorial supply distributor for recommendations on proper chemicals.
NOTE: There are
2
positions for the adjustable wheel (pull out the plunger (
26
) for adjusting).
Position
1
: machine can be tiled backwards and the brush / pad driver can be installed.
Position
2
: for normal operation and transportation.