Ice I18B, Operator'S Manual, Page: 12 / 33

ICE I18B/I18C
12
OPERATOR MANUAL
BASIC TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
No Power
The wiring not connected
correctly or bad wiring
Check the wiring or contact ICE Distributor
Bad brush motor Contact ICE Distributor
Carbon brushes worn out Contact ICE Distributor
Vacuum
motor does
not run
The wiring not connected
correctly or bad wiring
Check the wiring or contact ICE Distributor
Bad vacuum motor Contact ICE Distributor
Carbon brushes worn out Contact ICE Distributor
Little or no
'
Bad ball valve Contact ICE Distributor
Bad solution valve Contact ICE Distributor
Ball valve position in need of
adjustment When ball valve is in horizontal position,the
' "
Poor water
pick up
Squeegee clogged Clean debris off squeegee with a damp towel
Squeegee blades worn Install new squeegee blades
Squeegee not mounted
correctly ‚ %%]!$
%% !
Vacuum hoses have a hole or
are loose Check hose connections and make sure they
% !
Vacuum hose may be clogged Check hose for debris and remove any clog.
Drain hose stopper is loose Tighten drain plug.
Vacuum motor is loose
Tighten vac motor mounting screws. Do not
over tighten or damage will occur.
cover tank is loose ‚ % #J
Recovery tank is full Drain recovery tank
Float shut off is clogged
#' % #J
and remove any debris
short
runtime*
Low battery charge Fully recharge batteries
Defective batteries Replace batteries
Batteries need maintenance See BATTERY MAINTENANCE
Faulty battery charger Repair or replace battery charger
* ONLY FOR I18B