15
The nuts do not need to be screwed down they should be left
at the end of the screws as seen here.
2.9 Fit the front boom to an approximate position.
Fit the front boom into the frame taking
care not to damage the plastic shim
located inside the front of the main frame.
Position the boom at approximately a
hands span from the base of the front
derailleur post to the end of the main
cruciform.
2.10 Fit the pedals
(
Your own if not ordered from us) –
Note
: the pedal threads are handed. The right hand pedal tightens in the
normal direction; the left-hand pedal has a left hand thread, and tightens in the opposite direction to normal.
Tighten the pedals to the torque shown in Appendix A
2.11 Adjust the seat angle
Check the tyres are inflated and then sit on the trike and decide whether the seat angle suits you. The seat
can be set more upright (it was set to maximum recline in section 2.8) by simply opening the seat mount
quick-release, sliding the seat mount off the quick-release, and slotting it back over using a different set of
slots.
