IC Realtime Pixim I-Sniper EL-720, Installation Manual

Page: 6 / 12

10 11
6-5. Video Monitor 6-8. Connecting to VIDEO and POWER
6-6. Power
6-7. RS-485 Cable
Please check if the model is 12VDC or 24VAC before the installation.
·
Impedance alliance in the system connection.
Make sure to connect the cable with the power off. Please locate the impedance switch
of each equipment as instructed.
- Locate the switch to Hi-z position for the interim equipment.
TGs–Šˆ›ŒG›ŒGšž›ŠG›–G^\ȳG–™G›ŒG“ˆš›GŒ˜œ—”Œ•›U
Interim equipment
(DVR, Multiflexer, Transmitter etc.)
Set the impedance S/W to Hi-z position.
Last equipment
(Monitor)
Set the impedance
zV~G›–G^\˟G—–š›–•
BNC - Fe
(Video out)
2P Terminal block
(Non-Polrity)
Connect Video cable with BNC-male connector to the monitor.
12VDC/24VAC Dual power camera
You can use either 12VDC Power or
24VAC Power source with non-polarity
connection.
TRX+(GREEN CABLE)
TRX-(BLUE CABLE)
5IFSFDPNNFOEFEBEBQUFSTQFDJGJDBUJPOJT%$7N""$7N"
1MFBTFDIFDLUIFTUBOEBSEQPXFSSFRVJSFNFOUCFGPSFDPOOFDUJOHUIFQPXFS
"EEJUJPOBMMZXBUFSQSPPGJOHXPSLJTOFFEFEBUUIFKPJOU FHXSBQQJOHXBUFSQSPPGUBQF