5
Figure 3-2
Step 1
Take the installation position map from the accessories bag and then put it on the surface of the ceiling or
the wall according to the cable exit position. Dig three holes according to the installation position map and
then take three expansion bolts from the accessories bag and put them to the holes you just dug.
Step 2
Use inner hex wrench to remove the three case locking screws and then remove the dome enclosure.
Step 3
Adjust the pedestal position according to the cable exit mode (ceiling/side). Pull the cable through the
cable side exit at the installation surface and the pedestal (Please skip this step if you want to use ceiling
exit mode). Line up the screw holes at the bottom of the pedestal to the expansion bolts in the installation
surface. Put three self-tapping screws to expansion bolts and then secure firmly. Now the pedestal is on
the installation surface.
Step 4
