IC nexus SBC21 Series, Quick Start Manual

Page: 38 / 43

Quick Start Guide SBC21/NSD21/EC 21
Page
38
5. Touch Panel Calibration
5.1 Android RTP re-calibrate procedure
If you want or need to calibrate the touch for any reason such as:

Touch is not accurate

You have changed output

It is your first boot after you updated firmware and set output.
Use the commands to calibrate after devices boot.
When device power on, please notice the messages from console show
‘adb_open’
,
while the message occurred, quick input or paste character
“stop”
and press
“Enter”
key to stop the system booting process. Further then input below commands:
adb_bind_config
adb_open
# stop
//now the system would stop and display stays at penguin icon
# ts_calibrator
//now there
would be a white ‘┼’ at left, it is calibration point
Here is an example of the console message.
When the calibration point
‘
┼
’
shows, please quickly and accurately touch the cross
on panel. Be careful that this calibrator is with timeout function. If it is timeout, just
input
ts_calibrator
again.