Information capture. Done right
™
866-798-4265
www.ibml.com
24
Any time the cables connected to the rear of a camera are removed or installed, first remove the ferrite assemblies from the cables;
then clip them on after all screws have been secured.
The ferrites located on the LED Module Control Cable Set and Camera Link cable should be removed prior to installation or removal of
any cables. Make sure to replace the ferrite once the cables are secure.
There are two “cable ties” that positively locate the position of the ferrites and they MUST be clipped on at that position in order to meet
engineering design specifications and satisfy EMI compliance.
Cable ties used to guide the ferrite placement
Ferrite shown located properly between the guides